Use this free calculator (beta) to compare STB-1 and TBF High Density Thermal Break pads for a connection. Enter the plate size, sustained load and temperature difference to see heat flow through the pad, how much it cuts heat flow through the steel member crossing the insulation, bearing stress, and, for STB-1, elastic and long-term deflection against the 5% creep limit.

BETAThis calculator is a beta version. It is still being tested and refined, and results may change as it is updated. Use it for preliminary comparison only; it is not a substitute for a connection design by the engineer of record. Found an issue? Let us know.

Inputs

Steel member area examples: W8×24 beam 7.08 in², W6×15 beam 4.43 in², HSS 4×4×1/4 3.37 in², L4×4×3/8 angle 2.86 in².

Thermal results

Structural results

For preliminary comparison only. Heat flow is one-dimensional. The connection estimate puts the steel member crossing the insulation (k = 374.5 BTU·in/hr·ft²·°F) in series with the pad; bolts, plates, surface films and two- and three-dimensional effects are not included, so real-world reductions are usually smaller than shown. STB-1 values: k = 1.055 BTU·in/hr·ft²·°F, compressive strength 48,000 psi, compressive modulus 830,000 psi (1" thick), long-term deflection 1.25 × elastic up to 2,000 psi, creep and permanent set limit 5% of thickness. TBF values: k = 0.32 / 0.38 / 0.53 and published compressive stress 560 / 1,100 / 2,150 psi. Final connection design is the responsibility of the engineer of record.

How the Calculator Works

  • Heat flow through the pad is Q = k × A × ΔT ÷ t, using the pad’s thermal conductivity k, area A, temperature difference ΔT and thickness t. The connection estimate models the steel member that crosses the insulation (k = 374.5 BTU·in/hr·ft²·°F, your member area and path length) in series with the pad. The pad-vs-steel figure compares the materials only.
  • Bearing stress is the sustained compressive load divided by the bearing area. Enter the effective bearing area from your connection analysis, or leave it blank to use the full plate.
  • Elastic deflection is stress × thickness ÷ compressive modulus (830,000 psi for STB-1).
  • Long-term deflection is 1.25 × elastic deflection, valid for bearing stresses up to 2,000 psi, checked against the design limit of 5% of the original thickness.

For bolt checks, detailing and a worked example, see the Structural Steel Thermal Break Design Guide. Unit help: thermal and structural unit conversions. Terms: thermal bridging glossary.

Request a Quote or Data Sheet

Send us your connection drawings, bolt schedule or load requirements and we will quote STB-1, TBF, washers and bushings cut and machined to your specification.

Call 800-580-4195 or use the form below. STB-1 typically ships in 5–7 days; TBF in as little as 3 days.